Cisco Security Advisory
Cisco Adaptive Security Appliance Software and Cisco Firepower Threat Defense Software MOBIKE Denial of Service Vulnerability
CVSS:3.0/AV:N/AC:L/PR:N/UI:N/S:C/C:N/I:N/A:H/E:X/RL:X/RC:X
-
A vulnerability in the Internet Key Exchange Version 2 Mobility and Multihoming Protocol (MOBIKE) feature for the Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a memory leak or a reload of an affected device that leads to a denial of service (DoS) condition.
The vulnerability is due to the incorrect processing of certain MOBIKE packets. An attacker could exploit this vulnerability by sending crafted MOBIKE packets to an affected device to be processed. A successful exploit could cause an affected device to continuously consume memory and eventually reload, resulting in a DoS condition. The MOBIKE feature is supported only for IPv4 addresses.Cisco has released software updates that address this vulnerability. There are no workarounds that address this vulnerability.
This advisory is available at the following link:
https://sec.cloudapps.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-20190501-asa-ftd-ike-dos
-
Vulnerable Products
This vulnerability affects the following Cisco products that are running a vulnerable release of Cisco ASA Software or FTD Software if configured for MOBIKE1:
- 3000 Series Industrial Security Appliances (ISAs)
- ASA 5500 Series Adaptive Security Appliances
- ASA 5500-X Series Firewalls
- ASA Services Module for Cisco Catalyst 6500 Series Switches and Cisco 7600 Series Routers
- Firepower 4100 Series
- Firepower 9300 Security Appliance
- FTD Virtual (FTDv)
1The MOBIKE support for IPsec IKEv2 remote access VPNs was added as of 9.8(1). The MOBIKE feature is always enabled and cannot be disabled by the user. See the Details section for more information.
MOBIKE is enabled for each Security Association only when the client proposes it and the ASA accepts it. The device should be considered vulnerable if Internet Key Exchange Version 2 (IKEv2) remote access VPN is configured. The administrator can issue the show running-config command and check for the crypto ikev2 enable
command and the tunnel-group type remote-access command (also called connection profile).For information about which Cisco ASA Software and FTD Software releases are vulnerable, see the Fixed Software section of this advisory.
Determining the Cisco ASA Software Release
To determine which Cisco ASA Software release is running on a device, administrators can log in to the device, use the show version | include Version command in the CLI, and refer to the output of the command. The following example shows the output of the command for a device that is running Cisco ASA Software Release 9.9.2.18:
ciscoasa# show version | include Version Cisco Adaptive Security Appliance Software Version 9.9.2.18 Device Manager Version 7.4(1) . . .
If a device is managed by using Cisco Adaptive Security Device Manager (ASDM), administrators can also determine which release is running on a device by referring to the release information in the table that appears in the Cisco ASDM login window or the Device Dashboard tab of the Cisco ASDM Home pane.
Determining the Cisco FTD Software Release
To determine which Cisco FTD Software release is running on a device, administrators can log in to the device, use the show version command in the CLI, and refer to the output of the command. The following example shows the output of the command for a device that is running Cisco FTD Software Release 6.2.0:
> show version ---------------------[ ftd ]--------------------- Model : Cisco ASA5525-X Threat Defense (75) Version 6.2.0 (Build 362) UUID : 2849ba3c-ecb8-11e6-98ca-b9fc2975893c Rules update version : 2017-03-15-001-vrt VDB version : 279 ----------------------------------------------------
Products Confirmed Not Vulnerable
Only products listed in the Vulnerable Products section of this advisory are known to be affected by this vulnerability.
Cisco has confirmed that this vulnerability does not affect the following Cisco products:
- Adaptive Security Virtual Appliance (ASAv)
- ASA 1000V Cloud Firewall
- Firepower 2100 Series Security Appliance
-
MOBIKE extends ASA remote access VPNs to support mobile device roaming. This support means the endpoint IP address for a MOBIKE device IKE/IPsec Security Association can be updated rather than deleted when the device moves from its current connection point to another.
For additional information about the MOBIKE feature, refer to About Mobike and Remote Access VPNs.
-
There are no workarounds that address this vulnerability.
-
Cisco has released free software updates that address the vulnerability described in this advisory. Customers may only install and expect support for software versions and feature sets for which they have purchased a license. By installing, downloading, accessing, or otherwise using such software upgrades, customers agree to follow the terms of the Cisco software license: https://www.cisco.com/c/en/us/products/end-user-license-agreement.html
Additionally, customers may only download software for which they have a valid license, procured from Cisco directly, or through a Cisco authorized reseller or partner. In most cases this will be a maintenance upgrade to software that was previously purchased. Free security software updates do not entitle customers to a new software license, additional software feature sets, or major revision upgrades.
When considering software upgrades, customers are advised to regularly consult the advisories for Cisco products, which are available from the Cisco Security Advisories and Alerts page, to determine exposure and a complete upgrade solution.
In all cases, customers should ensure that the devices to be upgraded contain sufficient memory and confirm that current hardware and software configurations will continue to be supported properly by the new release. If the information is not clear, customers are advised to contact the Cisco Technical Assistance Center (TAC) or their contracted maintenance providers.
Customers Without Service Contracts
Customers who purchase directly from Cisco but do not hold a Cisco service contract and customers who make purchases through third-party vendors but are unsuccessful in obtaining fixed software through their point of sale should obtain upgrades by contacting the Cisco TAC:
https://www.cisco.com/c/en/us/support/web/tsd-cisco-worldwide-contacts.htmlCustomers should have the product serial number available and be prepared to provide the URL of this advisory as evidence of entitlement to a free upgrade.
Fixed Releases
Customers are advised to upgrade to an appropriate release as indicated in the applicable table in this section. To ensure a complete upgrade solution, customers should consider that this advisory is part of a collection that includes the following advisories:
- cisco-sa-20190501-asa-csrf: Cisco Adaptive Security Appliance Software Cross-Site Request Forgery Vulnerability
- cisco-sa-20190501-asa-frpwrtd-dos: Cisco Adaptive Security Appliance Software and Cisco Firepower Threat Defense Software TCP Timer Handling Denial of Service Vulnerability
- cisco-sa-20190501-asa-ftd-dos: Cisco Adaptive Security Appliance Software and Firepower Threat Defense Software WebVPN Denial of Service Vulnerability
- cisco-sa-20190501-asa-ftd-entropy: Cisco Adaptive Security Appliance Software and Firepower Threat Defense Software Low-Entropy Keys Vulnerability
- cisco-sa-20190501-asa-ftd-ike-dos: Cisco Adaptive Security Appliance Software and Cisco Firepower Threat Defense Software MOBIKE Denial of Service Vulnerability
- cisco-sa-20190501-asaftd-saml-vpn: Cisco Adaptive Security Appliance Software and Firepower Threat Defense Software VPN SAML Authentication Bypass Vulnerability
- cisco-sa-20190501-asa-ipsec-dos: Cisco Adaptive Security Appliance Software IPsec Denial of Service Vulnerability
- cisco-sa-20190501-firepower-dos: Cisco Firepower Threat Defense Software TCP Ingress Handler Denial of Service Vulnerability
- cisco-sa-20190501-frpwr-dos: Cisco Firepower Threat Defense Software Packet Processing Denial of Service Vulnerability
- cisco-sa-20190501-frpwr-smb-snort: Cisco Firepower Threat Defense Software SMB Protocol Preprocessor Detection Engine Denial of Service Vulnerabilities
- cisco-sa-20190501-sd-cpu-dos: Cisco Adaptive Security Appliance Software and Firepower Threat Defense Software WebVPN Denial of Service Vulnerability
In the following table(s), the left column lists Cisco software releases. The center column indicates whether a release is affected by the vulnerability described in this advisory and the release that includes the fix for this vulnerability. The right column indicates whether a release is affected by all the vulnerabilities described in this collection of advisories and which release includes fixes for those vulnerabilities.
Cisco ASA Software
Cisco ASA Software Release Recommended Release for This Vulnerability Recommended Release for All Vulnerabilities Described in the Collection of Advisories Prior to 9.41
Not vulnerable 9.4.4.34 9.4
Not vulnerable 9.4.4.34 9.51
Not vulnerable 9.6.4.25 9.6 Not vulnerable 9.6.4.25 9.71 Not vulnerable 9.8.4 9.8 9.8.4 9.8.4 9.9 9.9.2.50 9.9.2.50 9.10 9.10.1.17 9.10.1.17 9.12 Not vulnerable Not Vulnerable Cisco FTD Software
Cisco FTD Software Release Recommended Release for This Vulnerability Recommended Release for All Vulnerabilities Described in the Collection of Advisories 6.0
Not vulnerable 6.2.3.12 6.0.1 Not vulnerable
6.2.3.12 6.1.0 Not vulnerable
6.2.3.12 6.2.0 Not vulnerable 6.2.3.12 6.2.1 Not vulnerable 6.2.3.12 6.2.2 6.2.3.12 6.2.3.12 6.2.3 6.2.3.12 6.2.3.12 6.3.0 6.3.0.3 6.3.0.3 6.4.0 Not vulnerable Not vulnerable To upgrade to a fixed release of Cisco FTD Software, customers can do one of the following:
- For devices that are managed by using Cisco Firepower Management Center (FMC), use the FMC interface to install the upgrade. After installation is complete, reapply the access control policy.
- For devices that are managed by using Cisco Firepower Device Manager (FDM), use the FDM interface to install the upgrade. After installation is complete, reapply the access control policy.
-
The Cisco Product Security Incident Response Team (PSIRT) is not aware of any public announcements or malicious use of the vulnerability that is described in this advisory.
-
This vulnerability was found during the resolution of a Cisco TAC support case.
-
To learn about Cisco security vulnerability disclosure policies and publications, see the Security Vulnerability Policy. This document also contains instructions for obtaining fixed software and receiving security vulnerability information from Cisco.
-
Version Description Section Status Date 1.1 Updated the FTD fixed releases table to indicate that FTD Software Release 6.3.0.3 is available. Fixed Software Final 2019-May-02 1.0 Initial public release. - Final 2019-May-01
-
THIS DOCUMENT IS PROVIDED ON AN "AS IS" BASIS AND DOES NOT IMPLY ANY KIND OF GUARANTEE OR WARRANTY, INCLUDING THE WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR USE. YOUR USE OF THE INFORMATION ON THE DOCUMENT OR MATERIALS LINKED FROM THE DOCUMENT IS AT YOUR OWN RISK. CISCO RESERVES THE RIGHT TO CHANGE OR UPDATE THIS DOCUMENT AT ANY TIME.
A standalone copy or paraphrase of the text of this document that omits the distribution URL is an uncontrolled copy and may lack important information or contain factual errors. The information in this document is intended for end users of Cisco products.